Your basket is empty.
Browse & Search Products

Linear ball bearings with angle error adjustment, closed

Housing, plastic
Track plates, roller bearing steel.
Balls, steel.
The linear ball bearings correspond to series 3 of ISO 10285 with automatic angle error adjustment. With double-sided seal. These bearings comprise a highly precise die-cast plastic truss in which the clipped-on track plates of roller bearing steel are installed. The plastic truss serves at the same time as return and seal retainer. The seal consists of a special polyamide material with a low friction coefficient. The linear ball bearing is held in place by a retaining ring acc. to DIN 471/472.

Recommended tolerances:
Shaft: h6
Housing: H7

Linear ball bearings with double-sided seal should be lubricated before installation.

The specified basic load ratings apply upon insertion of hardened and ground shafts.
Temperature range:
-20 C up to +80 C.


Product Selection

NameOrder No.PriceOrderDD1D2LL1L2Dynamic base loads NStatic base loads NApprox. weight kgSurface finishPriceOrder
12222132 -0,222,9 -0,21,36505200,023closed£30.07
162624,936 -0,224,9 -0,21,38006300,028closed£31.10
203230,345 -0,231,5 -0,21,6150012500,061closed£39.08
254037,558 -0,344,1 -0,31,85250022000,122closed£51.59
304744,568 -0,352,1 -0,31,85320028000,185closed£69.85

Technical Drawing

Request Information

If you would like to know more about this, or any of our products, please complete the form below or call on 01455 611116

Related Products

Unit 11 Sketchley Meadows, Sketchley Meadows Industrial Estate, Hinckley, Leicestershire, LE10 3EN